Cutting

Usually  ropes are supplied in cut lengths, with "tapered" ends made by annealing. If the rope is required to be cut during assembly the rope shall be seized each side of the cut, to prevent damage from opening strands and/or changing lay length.

One seizing either side of the cut is normally sufficient for preformed ropes. For "rotation resistant" and special wire ropes a minimum of two seizings each side of the cut will be necessary. The length of each seizing should be a minimum 2 x rope diameter.

Cutting should be made with a high speed abrasive disc cutter, cutting torch or other suitable mechanical or hydraulic shearing equipment.  

After the rope has been cut the seizing should be left until all the wires are welded or otherwise secured.

WARNING! Incorrect cutting can cause damage to the rope. Be extra careful when cutting rotation resistant ropes.

Use safety goggles and other appropriate safety equipment when using a disc cutter or other mechanical or electrical devices.

Product inquiry

"Seizing"
"Seizing"

Certex Finland Oy * Juvan teollisuuskatu 25 C * 02920 Espoo * Puh: 0201 550 220 * sales@certex.fi